Python EC-2 Kantom Eye
by Alienonawall
uploaded 2016-10-07
64 downloads /
3
points
SPH
stock aircraft
#propeller #drone #replica #spy #phantomeye

Description

Boeing Phantom Eye replica. Prop engines made from MrNuclearturkey’s design.

To launch:
-decouple props
-spin them up. Without SAS enabled, press Alt+E until the right engine’s roll slider is trimmed to one side and Alt+Q until the left engine’s roll slider is trimmed to one side.
-detach from launch clamp
-at around 37 m/s pull up. Decouple the trolley.

Cruise speed ~45 m/s. The aircraft isn’t very maneuverable. Best climb rate is 5-10 m/s, with the nose pointed at 10 degrees.

To land:
-leave the engines spinning. Lower the two landing gear and put it on the ground.
-once the aircraft has landed, enable brakes and SAS on the engines.

Built in the SPH in KSP version 1.2.0.

Details

  • Type: SPH
  • Class: aircraft
  • Part Count: 353
  • Pure Stock
This craft was built during the pre-release phase of KSP more info
swipe to switch images, tap to close
K
S
P